Installation of oil level sensor

① If it is an old car, remove the original sensor. Direct installation of new cars;

② Please check the accessories before installation: flanges, rubber gaskets, O-rings, screws are complete and consistent;

③ Put the O-ring on the root of the sensor;

④ Apply oil-resistant sealant on both sides of the rubber gasket, then align the holes with the flange and the tank flange, and fix them with screws. When tightening, the force should be applied symmetrically to ensure uniform force in all directions to avoid oil leakage ；

⑤ Insert the sensor and tighten it with a wrench to complete the installation of the sensor;

⑥ Connect the power cord and communication line separately according to the definition;

⑦ Check that the circuit is normal, then the sensor can be powered on and the sensor can work normally;